Extron Electronics JMP 9600 User Guide - Manual (Page 96)

Figure 69 shows using the Edit Playlist Properties dialog box to set the master player to
generate an LTC (
a ) that starts counting up from 01:00:00:00 (exactly 1 hour) ( b ) once the
play or TCStart command is received.
2
1
Figure 69. Generate an LTC
Figure 70 shows using the Edit Playlist Properties dialog box to generate an LTC that starts at
01:00:00:00 (
c ) once the play command is received, but to delay the start of the video play
until 01:00:10:00 (by 10 seconds) ( d ). This creates a 10 second pre-roll period.
4
3
Figure 70. Delay Video Start
Figure 71 shows using the Edit Playlist Properties dialog box to generate an LTC starting
at 01:00:00:00 (
e ) once the play command is received, start the video 10 seconds later
(10-second delay) ( f ), and run the LTC on until 01:05:00:00 ( g ). If the video presentation is
4 minutes and 30 seconds, this results in a 30-second post-roll period.
6
7
5
Figure 71. Set an LTC Stop
JMP 9600 Media Player • Detailed System Interaction 90