Extron Electronics JMP 9600 User Guide User Manual
Page 24
Playlist and Clip fields
These fields display whether a playlist or clip is loaded. Empty fields indicate that no playlist
or clip is loaded. They also are used with menu controls to load a playlist or clip.
Select and load a playlist or clip as follows:
NOTES:
•
You must have created one or more playlists using the HTML pages before
any are available for selection to select (see “
“HTML Operation” section).
•
Ensure that the media player is configured for 1-channel output before
attempting to load 4:4:4 chroma subsampled content. If the player is
configured for 2-channel output mode and 2-channel locked output mode,
these formats will not load. Use the
the video mode and change it if necessary.
•
In 2-channel locked output mode, the files for the two channels must have
the same number of frames, resolution, bit depth, and number of audio
channel and must use 4:2:2 chroma subsampling. If these conditions are not
met, the files will not load.
•
The player must be correctly configured for the clip or playlist that you select
using the
, or else the player does not load the
selected clip or playlist and the LCD reports ERROR.
•
If you cannot get a clip to load, see “
Setting the clip or playlist to
“ in the “HTML Operation” section to view the
properties of the clip, which can help reveal the problem.
•
If you load a new clip with a different resolution and frame rate than the
currently loaded clip, it can take up to 4 seconds before it is ready to play.
1.
Rotate the encoder knob as necessary to highlight the
Playlist field or Clip field as shown at right.
2.
Press the Enter button. The Select a playlist screen (a list of playlist files) or Select a clip
folder screen (a list of DCP folders) appears (see figure 12).
Select a playlist
Select a clip
3
3
Figure 12.
Select a Playlist Screen and Select a Clip Folder Screen
3.
Rotate the encoder knob as necessary to highlight
the desired playlist file or clip folder.
4.
Press the Enter button.
When loading a playlist — The LCD returns to the Channel Status screen with the
playlist selected in step 3 shown in the Playlist field. The Play/Pause button flashes. The
procedure is complete.
JMP 9600 Media Player • Operation
18