Video and audio outputs – Extron Electronics JMP 9600 User Guide User Manual
Page 13
Video and Audio Outputs
a
Digital Video Outputs, DVI-I connectors — Connect one or two DVI displays to
the DVI-I-1 and DVI-I-2 connectors for the direct digital image and RGB video output.
Figure 5 defines the pinout for the DVI protocol.
Pin
Signal
1
TMDS data 2–
TMDS data 2+
TMDS data 1–
TMDS data 1+
DDC clock
+5 V power
DDC data
TMDS clock+
Ground (+5 V)
Analog V sync
TMDS clock–
Hot Plug Detect
TMDS data 0–
TMDS data 0+
TMDS data 4–
TMDS data 4+
TMDS data 3–
TMDS data 3+
TMDS data 5–
TMDS data 5+
TMDS data 2/4
shield
TMDS data 1/3
shield
TMDS data 0/5
shield
TMDS clock
Shield
Pin
Pin
Signal
Signal
2
9
10
17
4
12
20
5
13
21
6
14
22
7
15
23
Analog red
Analog RGB Gnd
Analog blue
C1
C3
C5
8
16
24
Analog green
Analog H sync
C2
C4
18
3
11
19
Male Connector (cable)
Female Connector
1
9
8
17
24 C3 C4
C1 C2
C5
Figure 5.
DVI Output Connectors
NOTES:
•
Both DVI connectors can output single-link DVI (digital) video and
traditional analog video.
•
DVI signals run at a very high frequency and are especially prone to errors
caused by bad video connections, too many adapters, or excessive cable
length. To avoid the loss of an image or jitter, follow these guidelines:
•
Do not exceed 16.4 feet (5 meters) of standard cable length.
•
Extron IN9700 cable can exceed 16.4 feet for single link of DVI-D.
•
Use only cables designed for DVI signals. Use of non-DVI or non-
HDMI cables or modified cables can result in a missing video output.
•
Limit or avoid the use of adapters.
Two DVI-A-to-VGA adapters are included with the media player that allow you to
accomodate an analog-only output on more standard connectors.
b
Digital Video Outputs, HD-SDI connectors — Connect one or two HD-SDI
1
devices to the HDSDI-1 and HDSDI-2 BNC connectors.
NOTE: A dual-link HD-SDI output requires using both connectors for a single video
signal and selecting the mode, either on the front panel (see “
“ in the “Operation” section) or via an MSVPP command (see the
command in the “Programming Guide” section).
c
Digital Audio Output connectors — Connect devices that can receive and
1-2
decode AES3-encoded audio to these 8 BNC connectors to receive up to
16 channels of audio.
NOTES:
•
The AES3 protocol supports two channels of audio on one BNC connector.
•
Media files that are encoded with 4:2:2 subsampled video support only
eight channels of audio. With 4:2:2 video:
•
Audio channels 1 through 8 are associated with video channel 1.
•
Audio channels 9 through 16 are associated with video channel 2.
JMP 9600 Media Player • Installation
7