Extron Electronics JMP 9600 User Guide - Manual (Page 59)

Genlock drop-down box — Select among the
genlock modes shown at right. The green bar in the
field indicates that your selection is being saved.
Black Burst PAL and Black Burst NTSC —
Receive a selected sync signal.
ES Genlock and ES MS9200 Genlock —
Receive ES Genlock or MS9200 Genlock as a slave.
NOTES: • ES Genlock and ES MS9200 Genlock are proprietary sync signals that are
native to Electrosonic products that have been acquired by Extron and to
older Electrosonic products.
• Only JMP 9600 2K units support ES genlock and MS genlock.
• When using ES Genlock or ES MS9200 Genlock, the video signal
resolution and frame rate must match on all players.
Master — Send ES Genlock genlock as a master.
NOTE: Media players with serial numbers 9600-01 through 9600-50 support the
Master, ES Genlock, and ES MS9200 Genlock sync types only (see “ About
menu ” in the “Operation” section to identify the serial number).
Trilevel — Receive a tri-level (HD video) sync signal.
Loop check boxes — Select (check) and deselect the channel loop modes as
desired.
Video analog setup dialog box
Figure 56. Video Analog Output Setup Dialog Box
Select between the Colorspace selections shown in figure 56. The green bar in the field
indicates that your selection is being saved.
Video HD-SDI setup box
Figure 57. Video HD-SDI Setup Dialog Box
JMP 9600 Media Player • HTML Operation 53