Extron Electronics JMP 9600 User Guide User Manual
Page 33
1.
Rotate the encoder to highlight the selection for the value or setting to be change (
a
on
on the preceding page
):
IP address — Interface 1 or 2, as applicable
Netmask 1 or 2 — Interface 1 or 2, as applicable
DHCP — Interface 1 or 2, as applicable
Gateway — Gateway
2.
Press the Enter button (
b
).
NOTES:
•
If DHCP is enabled, the IP address and Netmask settings are disabled.
Disable DHCP (steps 1, 2, 5, and 6) to change the IP address and Netmask
settings.
•
For a Gateway address, proceed to step 3.
•
For DHCP, skip to step 5.
•
For IP addresses and Netmask addresses, skip to step 9.
3.
For a Gateway address, Rotate the encoder as necessary to select the LAN port
(Interface 1 or Interface 2) to use as a gateway (
c
).
4.
For a Gateway address, press the Enter button. The
Apply
control appears in the
LCD. Proceed to step 9.
5.
To toggle DHCP on or off, rotate the encoder as necessary to highlight the
Enable
DHCP
selection (
d
).
6.
To toggle DHCP on and off, press the Enter button. The
Apply
control appears in the
LCD.
7.
If you enabled DHCP or you do not want to manually set the addresses, proceed to
step 15.
8.
To manually set addresses after disabling DHCP, proceed to step 9.
9.
Rotate the encoder to highlight the first or next octet that needs to be changed (
e
).
10.
Press the Enter button.
11.
Rotate the encoder to change the selected octet to the desired value (
f
).
12.
Press the Enter button. The highlight jumps to the next octet.
13.
Repeat steps 9 through 12 as necessary to change all octets.
14.
Press the Enter button.
15.
Rotate the encoder as necessary to highlight the
Apply
control (
g
).
16.
Press the Enter button (
h
).
JMP 9600 Media Player • Operation
27