Extron Electronics JMP 9600 User Guide - Manual (Page 62)

Default IP Addresses
To access the media player via either LAN port, you need the IP address for the port that you
are using, and may need the netmask mask and the gateway address. The factory-specified
defaults are:
• IP address (port 1): 192.168.254.254 • IP address (port 2): 192.168.254.253
• Netmask mask: 255.255.0.0 • Gateway address: 0.0.0.0
• DHCP: off
These values can be viewed and changed from the front panel (see “ Networking
submenu “ in the “Operation“ section).
Opening the embedded HTML MSVPP page
The simplest way to establish communications between the player and the controlling device
is via the built-in HTML MSVPP page. Open the HTML MSVPP page as follows:
1. On your computer, start the web browser program such as Microsoft Internet Explorer.
2. Click in the Address field of the browser.
3. Enter enter /msvpp.html in the Address
field of the browser, where “ msvpp.html ” is case sensitive.
4. Press the keyboard key. The player downloads the MSVPP page (see figure 59).
Figure 59. MSVPP Page
JMP 9600 Media Player • Programming Guide 56