Extron Electronics JMP 9600 User Guide - Manual (Page 53)

Setup Functions
A wide variety of communications, video, and audio setup functions,
necessary to ensure peak performance of the player and the video/audio
playback, are available using the Setup palette of tools (see figure 47). To
select the setup functions, from the Playlist Editor page, click the
Setup
Editor link at the top right of the page.
Figure 47. Setup Palette
Audio Setup Dialog Box
The Audio setup dialog box (see figure 48) provides controls to set the volume and audio
delay variables for the one or two output groups and to mute one or both outputs.
Media player set to 2-channel or
2-channel locked output
Media player set to 1-channel output
Figure 48. Audio Setup Dialog Box
NOTES: • The image shown on the left in figure 48 shows the audio setup dialog
box when the media player is set to either 2-channel or 2-channel locked
output. The dialog box on the right is 1-channel locked output. Use the
Setup > Video > Mode dialog box submenu to select the mode.
• Audio is unmuted (is output) when power is cycled.
To adjust the volume and delay values, click the up or down buttons ( ) as necessary. The
green bar in the field indicates that your selection is being saved.
To toggle audio mute on and off, click the appropriate Mute check box. Mute disables the
audio output from all 16 audio channels when the media player is in 1-channel mode. Mute
disables audio channels 1 through 8 for video channel 1 and audio channels 9 through 16
for video channel 2 when the media player is in 2-channel or 2-channel locked mode.
Click the to close the dialog box.
JMP 9600 Media Player • HTML Operation 47