Extron Electronics JMP 9600 User Guide User Manual
Page 31
Slider-type controls — The GUI/Video control adjusts the mix of the video image and the
graphical user interface (the “alpha blend”). The Brightness and Contrast controls function
the same as similar controls on any video monitor. Adjust the display controls as follows:
1.
Rotate the encoder to highlight the desired variable.
2.
Press the Enter button.
3.
Rotate the Encoder knob to adjust the setting:
GUI/Video — All the way to the left displays 100% of the GUI control. All the way to
the right displays 100% of the video image.
Brightness — Left (0) is darker, right (100) is brighter. The default setting is 0.
Contrast — Left (0) is maximum contrast, right (100) is minimum contrast. The default
setting is 30.
NOTE: The adjustments take effect as you make them in step 3.
4.
Press the Enter button to confirm the setting and continue to the next parameter.
—or—
Press the Previous button to confirm the setting and return to the previous menu.
Button-type controls — The Turn OFF LCD backlight control turns the LCD off. This can
be helpful to reduce distraction when the player is in the same room as the presentation.
The Factory Settings control returns the LCD settings to their factory defaults. Operate
these controls as follows:
1.
Rotate the encoder to highlight the desired control.
2.
Press the Enter button.
NOTE: Turn the LCD back on by pressing either the Enter, Previous,
Frame mode (
), or Shuttle mode (
) button or by cycling power.
Networking submenu
The Networking submenu (see figure 21) provides tools to set up the media player for
use in a LAN. Use this submenu to access and change all of the port settings for both
Ethernet connections of the media player (see “
” and
,
on the next page) and to ping another device on the network (see “
, on page 28).
Figure 21.
Networking Submenu
NOTE: Two LAN ports allow the media player to reside on two different subnets
simultaneously.
JMP 9600 Media Player • Operation
25