About setup dialog box – Extron Electronics JMP 9600 User Guide User Manual
Page 60
HDSDI Mode — Select between the output
*
*
*
* These selections are available
in 1 channel mode only.
modes shown at right. The green bar in the field
indicates that your selection is being saved.
NOTES:
•
The Dual Link High Framerate,
available on the JMP 9600 2K
model only, supports resolutions
of up to 1920x1080 and
2048x1080 at 48, 50, and 60 Hz. The player must be set to 2-channel-locked
mode to select this rate. See “
Interaction” section for more details on this mode.
•
You can configure the media player signal combinations that are not defined
within the video payload identifier specification (SMPTE 352); for example
single channel, dual link HD-SDI operation with 12-bit, 4:2:2 color sampling
and the RGB color space. Some displays may not correctly display such an
image or may require manual adjustment. The video payload identifier is
updated correctly when the next valid SMPTE 352 format is selected.
Colorspace — Select between the Colorspace
selections shown at right. The green bar in the
field indicates that your selection is being saved.
VPI enable check box — Select (check) and deselect VPI as desired.
NOTE: The player ships with the dual-link HD-SDI VPI tag on by default. You may chose
to turn it off for backwards compatibility or legacy support.
About Setup Dialog Box
NOTE: The media player must run firmware version 2.06.07 or newer. If you have
an older version, update the firmware to ensure proper operation (see “
“ in the “Detailed System Interaction”
section).
The About setup dialog box (see figure 58) displays the exact media player model, revision
levels, and disk usage information. Firmware revision (to identify when upgrades are
necessary) and disk usage (to determine if there is room for loading more clip files) are of
particular interest.
Figure 58.
About Setup Dialog Box
NOTE: The revision levels shown in figure 58 are examples only.
JMP 9600 Media Player • HTML Operation
54