Extron Electronics ISS 408 - Manual (Page 50)

Command and Response Table for SIS Commands (continued)
ISS 408 Integrated Seamless Switcher • Programming Guide 44
Command Function SIS Command
(Host to Unit)
Response
(Unit to Host)
Additional description
Pixel phase
Set a specific pixel sampling phase X@ * X1^ U X@ Phs X1^] Specify the pixel sampling phase.
Increment sampling value X@ +U X@ Phs X1^] Increase the phase value.
Decrement sampling value X@ –U X@ Phs X1^] Decrease the phase value.
View the sampling value X@ U X1^] Show the pixel sampling phase.
Horizontal detail filter (RGB and component video inputs)
NOTES:
•
The horizontal detail filter is available only for RGB and component video inputs. The same command with a different X` variable is
available to set a combined detail filter for S-video and composite video inputs.
•
The X@ value specified is the output to which the filtered input is switched.
•
The command (D) is case sensitive.
Set a specific filter value X@ * X1& D X@ Dhz X1&] Set the horizontal detail level.
Increment filter value X@ +D X@ Dhz X1&] Increase the horizontal detail level.
Decrement filter value X@ –D X@ Dhz X1&] Decrease the horizontal detail level.
View the horizontal filter value X@ D X1&] Show the horizontal detail level.
Vertical detail filter (RGB and component video inputs)
NOTES:
•
The vertical detail filter is available only for RGB and component video inputs.
•
The X@ value specified is the output to which the filtered input is switched.
•
The command (d) is case sensitive.
Set a specific filter value X@ * X1* d X@ Dvz X1*] Set the vertical detail level.
Increment filter value X@ +d X@ Dvz X1*] Increase the vertical detail level.
Decrement filter value X@ –d X@ Dvz X1*] Decrease the vertical detail level.
View the vertical filter value X@ d X1*] Show the vertical detail level.
Detail filter (S-video and composite video inputs)
NOTES:
•
Composite and S-video inputs support a single detail filter only, rather than separate horizontal and vertical filters. To apply a detail
filter to the scaled output when the input is composite video or S-video, use the same command as the horizontal filter (D) with the
X1* variable.
•
The X@ value specified is the output to which the filtered input is switched.
Set a specific filter value X@ * X1* D X@ Dhz X1*] Set the detail filter level.
Increment filter value X@ +D X@ Dhz X1*] Increase the detail filter level.
Decrement filter value X@ –D X@ Dhz X1*] Decrease the detail filter level.
View the vertical filter value X@ D X1*] Show the detail filter level.
Auto Memories
Auto memories on 1M Aut1 ] Set the ISS to apply auto memories
settings to all selected inputs.
Auto memories off 0M Aut0 ] Set the ISS to not apply auto
memories settings.
View auto memories status M X#] Auto memories is X# (on or off) for all
inputs.
NOTE : X@ = Output number 1 (program) or 2 (preview)
X# = Auto memories status 0 = off, 1 = on
X1^ = Pixel sampling phase 000 thru 031
X1& = Horizontal filter value 0 thru 3
X1* = Vertical filter or composite/S-video detail filter 1 thru 7