Extron Electronics ISS 408 - Manual (Page 43)

ISS 408 Integrated Seamless Switcher • Programming Guide 37
Cutting or dissolving in swap mode
The switcher issues the following reports when you swap the preview and program outputs
in swap mode:
TkeX$] (SIS operation response only) The switcher has
received the SIS “Take” (
% ) command.
Bsy1] The switcher is busy and will not respond to any SIS
commands.
Out1 • InX! • All (or RGB or Aud ) ] The input to the program output has changed (to the
input that
had been switched to preview output).
Out2 • InX! • All (or RGB or Aud ) ] The input to the preview output has changed (to the
input that
had been switched to program output).
Bsy0] The switcher is no longer busy and is able to respond
to SIS commands.
Input and Output Video Type
X!TypX%]
A front panel input video type selection has occurred. X! is the input number and X% is the
input video type.
RteX^X&]
A front panel output video format selection has occurred. X^ is the output resolution and X&
is the output refresh rate.
SynX*]
A front panel output video type selection has occurred. X* is the output video format
(RGBHV or RGBS).
PolX(]
A front panel output video polarity selection has occurred. X( is the output sync polarity.
Picture Adjustments
X@ColX1)]
A front panel color adjustment has occurred. X@ is the output number switched to the
adjusted input and X1) is the color variable.
X@TinX1!]
A front panel tint adjustment has occurred. X@ is the output number switched to the adjusted
input and X1! is the tint variable.
X@BrtX1@]
A front panel color brightness adjustment has occurred. X@ is the output number switched to
the adjusted input and X1@ is the brightness variable.
X@ConX1@]
A front panel contrast adjustment has occurred. X@ is the output number switched to the
adjusted input and X1@ is the contrast variable.
X@HszX1#]
A front panel horizontal size adjustment has occurred. X@ is the output number and X1# is the
size variable.