Extron Electronics Matrix 12800 Series User Guide - Manual (Page 81)

Programming Guide, cont’d
Matrix 12800 Switchers • Programming Guide 4-16
PRELIMINAR
Y
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional
description
Information requests
Information request,
system I X2!
X
X2@
•T
X2#
•U
X2$
•M
X2%
X
X2^]
Input size X output size,
BME type connected,
number of BMEs, input map
and output map.
Example: I 128X128 T1 U6 M128X128
]
Information request,
specific BME X#
I
X2!
X
X2@
•T
X2#
•U
X2$
•M
X2%
X
X2^]
N Where
X2!
is O, the command is equivalent to system “I” command, above.
Request part number N 60-xxx-iocr Contact Extron for part
numbers.
N xxx = 410 = Wideband video 411 = Sync
412 = Audio 530 = low resolution video
io Two-character (video) or four -character (audio) input/output matrix configuration code
c Redundant controller installed 0 = no, 1 = yes
r Redundant power supplies installed 0 = no, 1 = yes
Request the part number of
a specific BME X#
N 60-xxx-iocr Contact Extron for part
numbers.
Query controller firmware
version Q X2&]
Example: Q 1.23
] The factory-installed BME
controller firmware version
is 1.23 (sample value only).
Query software version for
a specific BME X#
Q
X2&]
Request fan status X#
*01S
X2*X2*X2*X2*]
Request power supply
status X#
*02S
X2*X2*X2*X2*]
Request controller status X#
*03S
X2(X2(]
Request input card status X#
*04S
X2(X2(X2(
...
X2(]
Request output card status X#
*05S
X2(X2(X2(
...
X2(]
Command and response table for SIS commands (continued)
N
X2!
= Input size The number of physical inputs
X2@
= Output size The number of physical outputs
X2#
= BME type 0= non existent 3 = sync
1 = wideband video 4 = stereo audio
2 = low res video 5 = mono audio
X2$
= Number of BME 1 through 8
X2%
= Input map size The number of virtual inputs
X2^
= Output map size The number of virtual outputs
X#
= BME number 0 – 8
X2&
= Video and audio mute: 0 = no mutes 2 = audio mute
1 = video mute 3 = video and audio mute
X2*
= Fan or power supply status 0 = not installed 2 = failed
1 = installed and working
X2(
= Card status 0 = not installed 3 = failed, both rails
1 = installed and working 4 = failed, negative rail
2 = failed, positive rail