Extron Electronics Matrix 12800 Series User Guide - Manual (Page 61)

Virtualization/Control Software, cont’d
Matrix 12800 Switchers • Virtualization/Control Software 3-28
PRELIMINAR
Y
Tools menu
Edit/View Config — Displays the Virtual Map screen, which
graphically presents the virtual map and allows you to
make changes to the map.
List Remote Keypads — Shows the status of all possible
MKP 1200 Remote Keypads. Information displayed
includes: address, mode, parameter, model and firmware
version (figure 3-18). To configure a keypad, select it,
click the Reconfigure Keypad button. Use the Mode
drop-down box to select Output mode, Global Preset
mode, or Room Preset mode. Use the Output # drop-
down box to change the output number. See the
MKP 1200 User Guide , for details.
Figure 3-18 — Remote Keypad screen
Assign Device Icons — Displays the complete set of input and output device icons.
You can drag any of these icons to the input and output boxes.
Edit Device Palette — Allows you to add your own device icon graphics.
RGB Delay settings — Displays the RGB Delay & Mute Adjust screen, from which
you can view and adjust the switching interval setting for each input.
Audio Gain settings — Displays the audio gain level setting for a single input or
for all inputs and allows you to change it.
Mute-Outputs settings — Displays the RGB Delay & Mute Adjust screen, from
which you can mute video, audio, or both for each input.
View Input Frequencies — Displays the input horizontal and vertical frequencies
for each input (DSVP).
Upgrade System — Starts the system upgrade wizard, which takes you through
the steps to save the current Matrix 12800 settings to the hard drive of the
controlling computer before you revirtualize your system.
IP options — Allows you to set IP options (see “ Ethernet protocol settings ” on
page 3-23).
HTML file manager — Displays a list of HTML files installed on the switcher and
allows you to upload custom files from a PC connected to the switcher .
Name Presets — Allows you to assign a name to each of the 32 global presets.
Show RS-232 Strings — Displays the ASCII commands that are used by the current
configuration. You can refer to these commands for RS-232 programming.
Initialize — Initializes and clears any or all of the following: ties, presets, audio
configuration, preset titles, icon names, and icons.