Preliminar y – Extron Electronics Matrix 12800 Series User Guide User Manual
Page 6

iii
Matrix 12800 Switchers • Table of Contents
PRELIMINAR
Y
Mail IP Address field ............................................................................................................5-7
User Name field ...................................................................................................................5-7
Password field ......................................................................................................................5-7
Email Address fields.............................................................................................................5-8
Set and View Ties page ............................................................................................................5-9
RGBHV Settings page .............................................................................................................5-10
Changing the input gain and attenuation (systems with audio BMEs) .........................5-11
Muting and unmuting one or all outputs........................................................................5-12
Changing the RGB delay ...................................................................................................5-12
Chapter 6 • Upgrades and Maintenance
.........................................................................6-1
Opening and Closing the Matrix Switcher
.................................................................6-2
Opening the switcher ...............................................................................................................6-2
Closing the switcher .................................................................................................................6-3
Removing and Installing the Fan Assembly
..............................................................6-4
Removing and Installing the Power Supply Module
...........................................6-6
Removing the power supply module ....................................................................................6-6
Installing the power supply module ......................................................................................6-7
Removing and Cleaning the Filter
...................................................................................6-9
Swapping the serial port protocol (RS-232/RS-422) ...........................................................6-10
Changing the serial port baud rate ......................................................................................6-11
Changing the sync termination ............................................................................................6-12
Removing and Installing the Controller Card and Replacing the
Removing the primary or redundant controller card ........................................................6-13
Updating the firmware ..........................................................................................................6-14
Installing the controller card .................................................................................................6-15