Xylem SuSix Turbidity and Suspended Solids Transmitter - Manual (Page 97)

97 FW: 841013-005/843003-001
Turbidity and Suspended Solids Transmitter
EN 5.10 SuSix Manual 1406
Info
Measurement hold Info - The measurement is set on
hold during the cleaning cycle or
by an error
.
Sensor needs cleaning Info - The sensor needs cleaning
real bad.
System reset occurred Info - The converter has been
subject to a software or hardware
reset.
Turbidity > 4000 NTU Info - The measured value has
exceeded 4000 NTUs. Clean the
probe.
USB
Flash programming please wait Programming is in progress but not
finished.
Flash programming done Programming is finished.
Flash crc error Cyclic redundancy check error.
Unknown command flash user text Unvalid command issued.
Flash address overrun
A write error hos occured.
File phase error Internal USB error.
File write failure A write error hos occured.
USB protocol overrun A communication error has oc-
cured.