Xylem SuSix Turbidity and Suspended Solids Transmitter - Manual (Page 78)

78 EN 5.10 SuSix Manual 1406 FW: 841013-005/843003-001
Turbidity and Suspended Solids Transmitter
Display Setup
The "Display Setup" menu provides options for language, clock and fac-
tory settings, Modbus parameters and software version display.
1. Press the up/down keys to highlight the required menu line
(here: Display setup) and then press OK to select it.
Specify Main Screen
Data Logger
Password
Set Sensor Name
Converter Setup
Display Setup
Back Select OK
Login
Activate/deactivate
Change password
Back Select OK
Set log interval
0010 sec
Back Select >
Data Logger
Set Sensor Name
SuSix1
Back Select >
Set Sensor Name
Select line
Linie 1 - Sensor name
Linie 2 - Meas.
Linie 3 -
Linie 4 -
Linie 5
Back Select OK
Specify Main Screen Converter Setup
Language
Set Clock
Modbus
Factory settings
Display SW version
Back Select OK
Display Setup
Sensor Calibration
Averaging
Units
mA output
Cleaning
Solid curve
High Alarm
Low Alarm
Sensor error
Status
Factory settings
Service Menu
Back Select OK
Select line content
Not in use
Meas.
Homogeneity
Solid curve
Clock
Back Select OK
Password
Type password
0000
Back Select >
Change password
0000
Back Select >
Activate
Deactivate
Back Select OK
Login
Activate/
Deactivate
Change password
SuSix1 [X]
Meas. FTU
Select Setup
Main Menu
Converter Top Display
SuSix1 [X]
Meas. FTU
Select Setup
Converter Top Display
Specify Main Screen
Data Logger
Password
Set Sensor Name
Converter Setup
Display Setup
Back Select OK
Main Menu
SuSix1 [X]
Prim. mg/l
Second 0.1%
Select Setup
1 - Main menus Page1
2. Press the up/down keys to highlight the required optione and then
press OK.
Time format
24 hour
AM/PM
Back Select >
Language
(GB) English
(US) English
Dansk
Deutsch
Español
Français
Italiano
Nederlands
Norsk
Suomalainen
Svenska
Back Select OK
Cancel
Delete log
Restore default language
Restore factory setting
Back Select OK
Change device addresse
Device 1
Back Select OK
Add device
Change device addresse
Remove device
Change controller ID
Back Select OK
Scanning
Back
Display 841013-002
SW July 14 2007 14:14:03
Language 841513-000
Back
Set clock Language Modbus Factory settings Display SW version
Add device
Devices found
Device 1
Back Select OK
Change device addresse
Change device 1
Back Select OK
Remove device
Device 1
Back Select OK
Remove device
Language
Set clock
Modbus
Factory settings
Display SW version
Back Select OK
Display Setup
Change controller ID
1
Back Select OK
Number of controllers
1
Back Select OK
Set clock
2007-08-18 10:53:12
Back Select >
Language
Set clock
Modbus
Factory settings
Display SW version
Back Select OK
Display Setup
Change controller ID
Susix 1 1.2 g/L
Susix 2 212 mg/L
Back Select Display
Display Overview Menu
Display configuration
2 - Display Setup Page2
The available options are described in detail on the following pages.