Xylem SuSix Turbidity and Suspended Solids Transmitter - Manual (Page 11)

11 FW: 841013-005/843003-001
Turbidity and Suspended Solids Transmitter
EN 5.10 SuSix Manual 1406
2. Safety, Repair and Product Identification
Safety instructions
• Read this manual carefully.
• Pay attention to the environment on the installation site.
• Wear necessary protective equipment and follow all current safety
regulations.
• SuSix ® can invoke a start signal for dangerous machinery. Always
ensure that connected machinery and other equipment are effectively
put out of service (that is to remove the main fuses and lock main and
security switches in off-position) before commencing configuration,
fault finding, servicing, maintenance work, etc.
• WARNING: There is a risk of lethal, electrical shock from the "Mains
supply" terminals "N" and "L". Be careful not to touch these terminals
while the SuSix
® is being serviced.
• WARNING: Incorrect installation or use can lead to body injury and/or
material damage!
Physical Mounting
The SuSix ® converter/display unit must not be mounted in explosion
hazardous areas!
SuSix
® may only be installed and commissioned by authorized MJK per-
sonnel, and all national and local regulations must be complied with.
Repair
Repair must only be made by authorized MJK personnel or by a service
representative approved by MJK.
Product Identification
A delivery will usually consist of a SuSix ® sensor and a SuSix ® converter
with or without a display unit.
Check that the item(s) delivered corresponds to the ordered item(s). The
part number is printed on an identification label sticked onto the converter
shipping box and on a label on the converter itself.