YSI P 700 IQ Analyzer - Manual (Page 107)

ba76133e01 09/2013 107
P 700 IQ
8.1.2 Info messages
The analyzer does not generate any info messages.
8.2 Status info
The status info is a coded piece of information on the current status of
a sensor. Each sensor sends this status info to the controller. The
status info of sensors consists of 32 bits, each of which can have the
value 0 or 1.
IC53Bx P700IQ-PO4 was successfully calibrated
* For calibration data, see calibration history
II13Bx Language not available,
Default language German
* Contact service
IC63Bx Liquid tank xxx almost depleted!
* Please refill to maintain proper functioning
EI155x Operational voltage too low
* Check installation and cable lengths, Follow installation instructions
* Power supply module(s) overloaded, add power supply module(s)
* Check terminal and module connections
* Defective components, replace components
EI255x Operational voltage too low, no operation possible
* Check installation and cable lengths, Follow installation instructions
* Power supply module(s) overloaded, add power supply module(s)
* Check terminal and module connections
* Defective components,
replace components
II155x Language not available,
Default language German
* Contact service
ES255x Component hardware defective xxx
* Contact service
EIA55x Communication between MIQ/WCA and P700IQ-PO4 disturbed
* Check cable connections
* Provide voltage supply to P700IQ-PO4
* Contact service
Message code Message text