SENA SS800 - Manual (Page 80)

80
6.5. Device Name Configuration
The Super Series has its own name for administrative purposes. Figure 6-5 shows the device name
configuration screen. When user changes Device name, hostname of Super Series shall be changed
and then prompt on CLI also shall be changed to the corresponding one as follows,
root@SS800_Device:~#
Figure 6-5 Device name configuration
Please note that user cannot set space character as one of device name. And If user sets blank as
Device name then hostname is set as IP address of Super Series automatically.
And also the device name is utilized for device identification at the management program, HelloDevice
Manager.
6.6. User Administration
The Super Series support user authentication for port access. The user for port access can be
configured User Administration menu as shown on Figure 6-6 User Administration. When user is
added, it is possible to assign ports for the user to be allowed to access. Please note that user
authentication should be enabled to enable user authentication for port and user authentication is
applied only for TCP mode. (Please also refer to the descriptions for User Authentication in Section
4.2.4.1. TCP Mode)
Figure 6-6 User Administration