SENA SS800 - Manual (Page 13)

13
2. Getting Started
This chapter describes how to set up and configure the Super Series.
- 2.1. Panel Layout explains the layout of the panel and LED indicators.
- 2.2. Connecting The Hardware describes how to connect the power, the network, and the
equipment to the Super Series and how to access the console port using a serial console or a
Telnet from remote location.
- 2.3. Accessing The Web Browser Management Interface describes how to access Web menu
from remote location.
The following items are required to get started.
- One power cable (included in the package)
- Console and Ethernet cables (included in the package)
- Cable kit (included in the package)
- One PC with Network Interface Card (hereafter, NIC) and/or one RS232 serial port.
2.1. Panel Layout
2.1.1. SS100 Panel Layout
The SS100 has six LED indicator lamps for status display. Uppermost lamp indicates the system
power-on status. Next lamp indicates the system running status. Third lamp indicates status of receive
and transmit of the serial port for data communication. Next three lamps indicate 100 Base-T Ethernet
connection, 10/100 Base Ethernet Link and Ethernet Activity, respectively.
Table 2-1 LED indicator lamps of the SS 100
Lamps Function
Power Turned on to RED if power is supplied Status
Ready Turned on to YELLOW if system is ready to run or running.
Blinking when an error is occurred. (Check the log to identify the source of
error. The log display is discussed on Section 6.2)
Serial port Rx/Tx Blink whenever there is any incoming or outgoing data stream through the
serial port of the SS100
100Base Turned on to GREEN if connected to 100 Base Ethernet network
Link Turned on to GREEN if connected to 10 or 100 Base Ethernet network
Ethernet
Act Blink whenever there is any activities such as incoming or outgoing packets
through the SS100 Ethernet port