SENA SS800 - Manual (Page 54)

54
4.2.5. Remote Host Configuration
Remote host configuration is the list of hosts that will receive data from serial port of Super Series
when there is data transmission from a serial port of Super Series.
In TCP mode, user can also configure secondary remote host that will receive data from serial port if
Super Series fails to connect to primary remote host. But if connection to primary remote host can be
made, Super Series dose not send data to secondary remote host until connection to primary remote
host failed. And the maximum possible number of primary remote host is limited up to 16.
In UDP mode, user can configure only primary remote host because there is no way for Super Series
to check status of primary remote host, so secondary remote host is meaningless.
Figure 4-8 shows Remote host configuration pages of the Web UI. (TCP mode)
Figure 4-8 Remote host configuration
4.2.6. Port IP Filtering Configuration
The remote hosts that are allowed to access the Super Series serial ports can be specified based on
the IP address filtering rules. The user may allow specific hosts to access the Super Series serial ports
by providing a valid IP address or network address and its subnet mask. Please refer to section 3.5. IP
Filtering for more details.