SENA SS800 User Manual

Page 34

must then enter the IP address and subnet of access. Any user on a remote host must stay in the

specified subnet boundary to have the configuration access.

To allow only a specific host to have configuration access to the Super Series, enter the IP address of

the specific host and just give 255.255.255.255 for the subnet.

To allow any hosts to have access to the Super Series, give 0.0.0.0 for both of the IP address and

subnet. Refer to Table 3-2 for more details. The device’s default settings for remote hosts allowed for

configuration is “Any”.

Figure 3-7 IP filtering Configuration

Table 3-2 Input examples of allowed remote hosts

Input format

Allowable Hosts

Base Host IP address

Subnet mask

Any host

0.0.0.0

192.168.1.120

255.255.255.255

192.168.1.1 ~ 192.168.1.254

192.168.1.0

255.255.255.0

192.168.0.1 ~ 192.168.255.254

192.168.0.0

255.255.0.0

192.168.1.1 ~ 192.168.1.126

192.168.1.0

255.255.255.128

192.168.1.129 ~ 192.168.1.254

192.168.1.128

255.255.255.128

Web access also uses the IP filtering function, which can be enabled or disabled. The factory default

setting is “Enabled”. When enabled, the user can specify a web host or hosts allowed to access the

Super Series for configuration.