SENA SS800 - Manual (Page 25)

25
3. Network Configuration
3.1. IP Configuration
The Super Series requires a valid IP address to operate within the user’s network environment. If the
IP address is not readily available, contact the system administrator to obtain a valid IP address for the
Super Series. Please note that the Super Series requires a unique IP address to connect to the user’s
network.
The users may choose one of three Internet protocols in setting up the Super Series IP address: i.e.,

Static IP

DHCP (Dynamic Host Configuration Protocol)

PPPoE (Point-to-Point Protocol over Ethernet)
The Super Series is initially defaulted to STATIC mode, with a static IP address of 192.168.161.5.
Table 3-1 shows the configuration parameters for all three IP configurations. Figure 3-1 shows the
actual web-based GUI to change the user’s IP configuration.
Table 3-1 IP configuration Parameters
IP address
Subnet mask
Default gateway Static IP
Primary DNS/ Secondary DNS
DHCP Primary DNS/ Secondary DNS (Optional)
PPPoE Username
PPPoE Password
PPPoE
Primary DNS/ Secondary DNS (Optional)
Figure 3-1 IP Configuration