SENA SS800 User Manual
Page 21
21
3)
Connect the other end of the cable to the serial port of the user’s computer.
4)
Run a terminal emulator program (i.e. HyperTerminal). Set up the serial configuration
parameters of the terminal emulation program as follows:
9600 Baud rate
Data bits 8
Parity None
Stop bits 1
No flow control
5)
Press the [ENTER] key.
6)
Enter your user name and password to log into the Super Series. The factory default user
settings are as follows.
Login: root
Password: root
Login: admin
Password: admin
192.168.161.5 login: root
Password:****
[email protected]:~#
7)
Upon authentication, the CLI are initially provided for configuration. For details on the CLI,
refer to the chapter 8. CLI Guide.
8)
“ss.edit” command will allow you to enter the text-menu driven interface and the menu
screen in Figure 2-15 is displayed.
[email protected]:~#ss.edit
------------------------------------------------------------------------------
Welcome to SS-800 configuration page
Current time: 08/22/2003 21:52:36
F/W REV.: v0.4.0
Serial No.: SS800438349-42944
MAC address: 00-01-95-04-19-5a
IP mode: DHCP
IP address: 192.168.14.7
------------------------------------------------------------------------------
Select menu:
1. Network configuration
2. Serial port configuration
3. PC Card configuration
4. System administration
5. Save changes
6. Exit without saving
7. Exit and apply changes
8. Exit and reboot
----->
Figure 2-15 The main menu screen (SS800)
From the main menu screen, the user may select the menu item for the configuration of the Super
Series parameters by typing the menu number and pressing the [ENTER] key. In the submenu screen,