SENA SS800 - Manual (Page 66)

66
all port buffer size of each serial port should be smaller than or equal to 3200 Kbytes). The factory
default setting is 4 Kbytes.
When using an ATA/IDE fixed disk card to store log data, the maximum port buffer size is dependent
upon the card capacity.
When using an NFS server to store log data, the maximum port buffer size is unlimited. The user
should configure the NFS server to ensure that the port logging system works properly.
When using the SYSLOG server to store log data, the user cannot set the port log buffer size.
Figure 4-17 Port logging configuration
4.2.12. Port Event Handling Configurations
The Super Series provides a user for a means of monitoring or reacting to data from serial device
attached to a serial port of it through Port event handling configuration. Namely, user can define
keywords for each serial port that will trigger the email/SNMP notification or command sent to the
serial port directly on Port event handling configuration. And this will enable the user to monitor the
data from the attached device or to manage/control a device attached serial port directly when pre-
defined keywords are detected. At the same time, the status of the connection between the Super