B&B Electronics 856-14205--29 - Manual - Manual (Page 6)

General Information
1
CHAPTER 1: GENERAL INFORMATION
INTRODUCTION
The iMcV-Giga-FiberLinX-III allows network operators to deploy managed
Ethernet services with a full range of remote management, traffic monitoring,
and alarm reporting features. The single wide module offers two fixed
10/100/1000Mbps copper ports and one fiber port in a fixed transceiver in a
variety of wavelengths for SMMM and CWDM. Another model offers an SFP port
that allows copper or fiber SFPs.
iMcV-Giga-FiberLinX-III
The iMcV-Giga-FiberLinX-III supports three main configuration modes:
Standalone,
Host/Remote, or as a Host or a Remote. When using Host/Remote,
the Remote modules can be fully managed without an IP address over the fiber
optic segment. The network operator can choose to assign an IP address to the
Host or Standalone module in any mode. Or, if using a local iMediaChassis
managed chassis, all local and remotely connected iMcV-Giga-FiberLinX-III
modules can be managed using the single IP address of the chassis. This not
only preserves IP addresses and reduces configuration complexity, but
management traffic traveling on the non-IP based transmission channel is kept
isolated from customer traffic, enhancing network security.
The iMcV-Giga-FiberLinX-III offers the following features:
 Securely separates the SNMP management network from the data
network
 IEEE 802.1Q VLAN Tagging
 Q-in-Q VLAN Extra-Tagging with EtherType (TPID) selection
 Remote traffic monitoring