B&B Electronics 856-14205--29 - Manual - Manual (Page 37)

Configuration
32
Unit Optics
Loopback There are five selections to determine connectivity over the
fiber run.
Unit Max
Framesize
Choose from three selections of frame sizes.
Boot Trap
Delay
Seconds
When connected to a switch, such as a Cisco switch, there is a
delay time for a boot sequence (typically about 30 seconds).
Enter a value of 30 seconds or more so that the device does
not send a Trap indicating the link is down.
Unit OAM
Enable Allows the end-user to enable or disable OAM. OAM
configuration can be set up via the CLI by accessing the
submenu and typing in the command OAM.
Port Configuration (port)
Serial/Telnet sessions display port status as well as allowing configuration of
some port features. Type port and press Enter to be taken to the Port screen.
From this screen, view the port speed, duplex and link status.
The Port screen contains the following commands:
Port
Enable Enable/Disable the port. (Select Enable to enable the port.)
Admin
Status
Set Administration status. (Select UP to enable/disable
management through the port.)