B&B Electronics 856-14205--29 - Manual - Manual (Page 35)

Configuration
30
(OPERATION AND ADMINISTRATION MANAGEMENT) OAM
Two modes of operations control the OAM function, Passive and Active. Passive
mode is the default mode. OAM Enable is defaulted to Enable.
OAM AH passive/active is available on the fiber SFP ports and TX ports
 Supports Discovery functions on the SFP ports.
 Supports reporting OAM Flag Events (Link Fault, Critical Event, and
Dying Gasp)
 Supports Loopback
VIEWING SFP STATISTICS (SFPSTATS)
To view SFP statistics on the iMcV-Giga-FiberLinX-III, enter sfpstats. This will
open a screen displaying SFP information, including vendor, serial number, bit
rate and other options.
Pressing the Space Bar will refresh the data on the screen.