B&B Electronics 856-14205--29 - Manual - Manual (Page 20)

Configuration
15
2c and press Enter. This function enables ALL of the device traps. Supported traps
include: Link Down, Link Up, and Last Gasp.
REMOVING TRAP DESTINATIONS
To remove all trap destinations, press K. Press Y to continue to confirm or N to abort and
remove all trap destinations. Press Enter to finish.
This function will delete all trap destinations. To selectively delete trap destinations or to
disable/enable Traps, use iView
2 (iConfig view) to configure the device. To enter another
Trap destination, repeat the steps listed above.
CREATING COMMUNITY STRINGS
Community strings add a level of security to a network. The default community string is
named "public" and has read/write access. For security, "public" should be replaced with
custom community strings such as ones created with read-only access (for general use),
and another with read/write access (for the administrator).
To create a new community string, go to the main configuration screen and press C.
Enter the name of the new community (up to 16 characters, no spaces) and press Enter.
Then type one of the following to assign the community string’s access rights:
 R = read-only access
 W = read/write access
 Enter = abort
After entering R or W, press Enter. To finish, press Enter and reboot.
DELETING COMMUNITY STRINGS
To delete all community strings, perform the following:
Press U. The "Are you sure you want to delete all community strings?" prompt is
displayed. Press Y when prompted to proceed and delete all community strings, N to
abort. Press Enter to finish.
This function will delete ALL community strings. To selectively delete community strings,
use iView 2 (iConfig view) to configure the device.