B&B Electronics 856-14205--29 - Manual - Manual (Page 22)

Configuration
17
COMMANDS LIST (SPACE BAR)
The iMcV-Giga-FiberLinX-III also includes several device-specific options. To access these
options, press the Space Bar from the Main Configuration screen, type the name of the
action to be performed (as shown below) and press Enter.
Command Description
cleandb Reboots the unit with a clean database. This removes all
information from the database and sets the unit to factory
defaults.
download Downloads firmware via the TFTP protocol
accounts Allows the addition for User, Operator, Admin
vlan Provides selection of three modes of operation to support all
VLAN configurations.
bw Displays settings for Bandwidth configuration
version Displays the unit’s firmware and hardware version
ifstats Displays interface statistics
rmstats Displays remote monitoring (RMON) statistics on packets
received as defined in RFC 2819 for RMON.
sysDescr Allows the editing of sysName, sysDescr, and Port information
reboot Allows a soft reboot of the unit after changes are made by the
end user
oam Allows an array of OAM configurations