Olympus IX2-DSU BX-DSU User Manual
Disk scanning biological microscope
Table of contents
Document Outline
- DISK SCANNING BIOLOGICAL MICROSCOPE
- CONTENTS
- INTRODUCTION- Be sure to read this section for safe use of the equipment. -
- I. System Outline
- II. DSU
- 2 SUMMARY OF OBSERVATION PROCEDURES
- 3 DETAILS OF EACH OPERATION
- 3-1 General Precaution for observation
- 3-2 Selection of fluorescent mirror unit
- 3-3 Table of Combination - Objective lens to each observation and applicable disk
- 3-4 Assignment of operating buttons on body (BX61, BX62 or BX61WI only)
- 3-5 Powering up
- 3-6 Focusing
- 3-7 Changeover of visual mirror unit (front side)
- 3-8 Disk IN/OUT
- 3-9 Shutter OPEN/CLOSE
- 3-10 Changeover of camera mirror unit (rear side)
- 3-11 Filter change
- 3-12 Adjustment of field iris diaphragm
- 3-13 Lamp centering
- 3-14 Camera focus alignment
- 3-15 Power shutdown
- 4 VARIETIES OF OBSERVATION METHODS
- 5 TROUBLESHOOTING GUIDE
- 6 SPECTRAL CHARACTERISTICS OF FILTERS
- 7 SPECIFICATIONS
- 8 ASSEMBLY
- 8-1 System block diagram
- 8-2 Installation of light illuminator
- 8-3 Installation of disk box
- 8-4 Removal of transportation lock
- 8-5 Installation of illuminator
- 8-6 Installation of lamp house
- 8-7 Installation of mercury lamp
- 8-8 Lamp power supply setting
- 8-9 Installation of front side turret
- 8-10 Installation of visual mirror unit (front side)
- 8-11 IN/OUT of rear side turret
- 8-12 Installation of camera mirror unit (rear side)
- 8-13 Disk installation and change
- 8-14 Installation of light shielding tube (BX61, BX62, BX51 or BX52)
- 8-15 Installation of UV-cut plate
- 8-16 Installation of filter or shutter (In case of U-FWR or IX2-SHA)
- 8-17 Filter IN/OUT inside motorized filter wheel
- 8-18 Field iris diaphragm IN/OUT
- 8-19 Installation of camera adapter and filter
- 8-20 Installation of camera
- 8-21 DIP switch settings on control box (BX61, BX62 and BX61W1 only)
- 8-22 Installation of motor drive board
- 8-23 Z board setting and installation