Olympus IX2-DSU BX-DSU - Manual (Page 63)

ASSEMBLY
/ Lamp power supply setting
II. DSU
II . 8 - 9 Page
8-8 Lamp power supply setting
Cord or cable is weak against bend or twist. Care must be
taken so as not to apply excessive force.
When connecting power cord, turn main siwtch to mark
side (OFF).
Use power cord that comes our accessory for sure.
1. Verify that voltage and frequency of input power are within the range as
shown in identifying plate (1).
(The 100 V system can be used with voltages in the 100 to 120 V range
and 200 V system can be used with voltages in the 220 V to 240 V range,
both with frequencies of 50 or 60 Hz.)
2. Connect connecting cord to connector (2) of power supply unit.
3. Install power cord to input receptacle (3) of power supply unit and insert
power plug (4) into power consent (5).
Power cord should be connected to 3-core consent with
earth terminal. When the earth of consent is not connected,
the electric safety performance intended by our company
may not be acquired.
(1)
(2)
(3)
(4) (5)