Olympus IX2-DSU BX-DSU - Manual (Page 58)

ASSEMBLY
/ Installation of disk box
II. DSU
II . 8 - 4 Page
8-2-2 In case of IX
1. Loosen fixing screws (1) (2 places) that fix light
illuminator to microscope frame, using the Allen
wrench.
2. Insert light illuminator (2) into mounting hole (3).
Observe that pin at lower part of light illuminator
is aligned with mounting hole slot.
3. Tighten fixing screws (1) for light illuminator
and fix the light illuminator (2 places).
8-3 Installation of disk box
1. Loosen fixing screws (1) (2 places), using the Allen
screwdriver.
2. Insert disk box (2) into light illuminator, observing pin
position, and push it until it hits the dead end.
3. Tighten fixing screws (1) (2 places), using the Allen
screwdriver.
4. Loosen fixing screw (3) of stand that comes as
accessory and put the stand underneath the
observation tube of disk box.
Stand should be attached for sure to
prevent upside down.
5. Extend the stand to apply fixing place to observation
tube and tighten fixing screw (3).
Note
(1)
(both sides)
(3)
(2)
(2)
(3)
(1)