VEGA VEGAPULS 81 - Manual (Page 74)

74 VEGAPULS 64 and 81
Parameter adjustment TAG…
(main menu stage)
–– Adjustment
–– With level
–– Min. adjustment
–– Max. adjustment
–– Without level
–– Adjustment in (unit)
–– Position correction (hydrostatic)
–– 0 % at (corresp. to the unit)
–– 100 % at (corresp. to the unit)
–– Processing
–– Scaling
–– 0 % corresp. to
–– 100 % corresp. to
–– Decimal point
–– relating to
–– Unit
–– Lin. curves (linear, round, spherical)
–– Integration time
–– Density or DK-value
(capacitive, hydrostatic)
–– Outputs
–– Current outputs
–– Current output (1, 2 or 3)
–– relating to
–– Unit
–– Current output (4/20; 0/20;
20/4; 20/0) (free)
–– Current at 0 %
–– Current at 100 %
–– at failure (0; 22)
–– Volt outputs
–– Volt output (1, 2 or 3)
–– relating to
–– Unit
–– Volt output (2/10; 0/10;
10/2; 10/0) (free)
–– Volt at 0 %
–– Volt at 100 %
–– at failure (0; 11)
–– Configuration outputs
–– Configuration current outputs
–– Current 1 to (co-ordination)
–– Current 2 to (co-ordination)
–– Current 3 standard (type)
–– Current 3 to (co-ordination)
–– Current 3 standard (type)
–– Configuration Volt outputs
–– Volt 1 to (co-ordination)
–– Volt 2 to (co-ordination)
–– Volt 3 to (co-ordination)
–– Configuration relay outputs
–– Adjustment relay
–– Rel. 1 to (co-ordination)
–– Rel. 1 standard (type)
–– Input
–– Rel. 2 to (co-ordination)
–– Rel. 2 standard (type)
–– Fail safe relay
–– Relay standard
–– Configuration PC/DCS-outputs
–– PC/DCS-measured values
–– DCS 1 to (co-ordination) MST1…
·
·
·
–– DCS 7 to (co-ordination)
–– PC/DCS-relay status (on, off)
–– PC/DCS-input status (on, off)
–– Configuration VEGADIS
–– PC/DCS-measured values
–– DIS 1 to MST1
–– DIS 2 to MST2
–– DIS 3 to MST3
–– DIS 4 to – –
–– DIS 5 to – –
–– DIS 6 to – –
–– DIS 7 to – –
Set-up: Menu survey of the signal conditioning instrument