Add and register a pendant, Getting started, Add and register a handset – VTech SN6197_-2 Manual User Manual
Page 23
You cannot register a handset if any other system device is in use.
The telephone base shows
Registration slots are full when you try
handset will prompt you to set the date and time after it is registered
to the base. To skip setting, press
•
•
•
When first purchased, charge the pendant in the pendant charger. You
hear three beeps every 10 seconds when the pendant is not registered.
The new pendant should be charged without interruption for at least
30 minutes before registering it to the telephone base.
Make sure the pendant is out of the pendant
when it is not in use.
Press or
Registering... Please wait.
Put the pendant in the pendant charger.
The pendant status light flashes red and
green to indicate the registration is in
appears on the telephone base, and both
devices beep. The pendant is now registered
with the telephone base. It takes up to 60
seconds to complete registration.
1.
2.
3.
4.