VTech SN6197_-2 Manual - Manual (Page 151)

Appendix
144
Energy-saving charging mode
When this mode is activated, all telephone functions, except handset battery charging,
will be disabled.
To activate the energy-saving charging mode:
Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are plugged with charged batteries.
While you press and hold
FIND HS, plug the telephone base power adapter back
to the power outlet.
After about 20 seconds, when the
IN USE light starts flashing, release FIND HS
and then press it again within 2 seconds.
When the phone successfully enters the energy-saving mode, the IN USE light
turns off and all handsets display To register HS, see manual.
When the phone fails to enter this mode, repeat Step 1 through Step 3 above.
Note: The telephone base will be powered up as normal if you fail to press FIND HS
within 2 seconds in Step 3.
To deactivate the energy-saving charging mode:
Unplug the telephone base adapter from the power outlet, then plug it back in.
Then the telephone base is powered up as normal.
Register your handset and pendant back to the telephone base. See
pages 15 through 17 for registration instructions.
Maintenance
Taking care of your telephone
Your telephone contains sophisticated electronic parts, so it must be treated with care.
Avoid rough treatment
Place the handset down gently. Save the original packing materials to protect your
telephone if you ever need to ship it.
Avoid water
Your telephone can be damaged if it gets wet. Do not use the handset outdoors in the
rain, or handle it with wet hands. Do not install the telephone base near a sink, bathtub
or shower.
Electrical storms
Electrical storms can sometimes cause power surges harmful to electronic equipment.
For your own safety, take caution when using electrical appliances during storms.
1.
2.
3.
1.
2.