Deleting assigned pushbuttons – Velleman VMB1LED User Manual
Page 30
VMB1LED PWM LED strip dimmer Manual– edition 1_rev.2
30
Deleting assigned pushbuttons
Remember the address of the dimmer module to reinstate it later on.
Set the address of the dimmer module to the function for which the pushbuttons must be deleted.
Address Operating function
F1
OFF:
to delete pushbuttons that switch off the LED strip
E1
ON:
to delete pushbuttons that switch on the LED strip (full brightness)
D1
TGL:
to delete pushbuttons that switch the LED strip on (full brightness) or off
C1
DIM:
to delete pushbuttons/sliding controls that activate the selected mode on
the module
B1
UP:
to delete pushbuttons that increase the LED strip brightness
A1
DWN: to delete pushbuttons that decrease the LED strip brightness
91
ATM:
to delete pushbuttons that light op the LED strip at a certain brightness
(atmosphere)
The indication LEDs of the pushbuttons that are linked to the selected function will flash.
Deleting an assigned pushbutton is done by pressing and holding it until its indication LED turns off.
Reinstate the original address of the dimmer module.