Velleman VMB1LED - Manual (Page 18)

VMB1LED PWM LED strip dimmer Manual– edition 1_rev.2
18
Terminator
Normally only 2 ‘TERM’ terminators must be used in a complete Velbus installation. Usually this will be on one
module inside the distribution box and on the module which is physically located furthest from the distribution box.
On all other modules, the terminator must be removed.
Remark:
In case the wiring contains a lot of branches, still only one terminator is placed on one module inside the
distribution box and one on the module which is physically located furthest from the distribution box. When
communication errors occur, an additional terminator can be used at the end of another branch. However, the
number of terminators should be limited as more terminators place a heavy load on the bus.
Terminator