Velleman VMB1LED - Manual (Page 17)

VMB1LED PWM LED strip dimmer Manual– edition 1_rev.2
17
Addressing
Every module in the Velbus system must have a unique address.
On modules with a rotary switch like this dimmer the address is set using the ‘ADDR’ rotary switch (also refer to
the manual of the relevant module). For modules without rotary switches e.g. control panel VMB4PD or
temperature controller VMB1TC the address is set via a menu (see manual of the VMB4PD or VMB1TC).
These addresses may not be altered afterwards.
Remove the cover.
Select a unique address from ‘01’ to ‘FE’ for the dimmer module using the ‘ADDR’ rotary switches, except
addresses ‘81’, ‘91’, ‘A1’, 'B1', ‘C1’, ‘D1’, ‘E1’, ‘F1’ and ‘FF’.
In the example below, the address is set to ‘12’.
ADDR = 12