beautypg.com

Velleman VTTEST14 User Manual

Vttest14 – audio cable tester

background image

VTTEST14

- 1 -

VELLEMAN

VTTEST14 – AUDIO CABLE TESTER

1. Introduction & Features

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm

the environment.

Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised

company for recycling.

This device should be returned to your distributor or to a local recycling service.

Respect the local environmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for buying the VTTEST14! Please read the manual thoroughly before bringing this device into service. If the

device was damaged in transit, don't install or use it and contact your dealer.

2. Use

Turn the rotary switch fully clockwise to test the strength of a battery. The battery LED will light bright green if the

internal battery is fully charged.

Plug one end of the cable into the appropriate jack on the left side of your VTTEST14. Plug the other end of the cable

into the appropriate jack on the right. Now, set the rotary switch to “1” to test the connection of contact “1” on the plug

inserted into the left. If there is a connection, the green LED will light below “1” while a yellow LED will light above the

contact of the plug connected to the right. If no LED lights, there is no connection. The left connection will either be

floating or open. Set the rotary switch to “2” to test contact “2” etc. until all contacts have been checked. If the

GROUND LED lights, there is a connection between the corresponding contacts and the chassis.

To test a cable with banana plugs, just plug each end of the cable into the banana jacks. The LED will light and the

unit will beep if there is a connection between the plugs. These jacks can also be used for continuity tests using two

probe leads.

¼” TS Mono to ¼” Mono

¼” TRS to ¼” TRS

1 Sleeve

1 Sleeve, 3 Ring

1 Sleeve

1 Sleeve, 3 Ring

2 Tip

2 Tip

2 Tip

2 Tip

3 Ring

1 Sleeve, 3 Ring
(shorted with sleeve)

3 Ring

1 Sleeve, 3 Ring

XLR Balanced to XLR Balanced

XLR Unbalanced to XLR Unbalanced

Pin 1

Pin 1

Pin 1

Pin 1, Pin 3

Pin 2

Pin 2

Pin 2

Pin 2

Pin 3

Pin 3

Pin 3

Pin 1, Pin 3

¼” TS Mono to XLR Unbalanced

¼” TRS to XLR Balanced

1 Sleeve

Pin 1, Pin 3

1 Sleeve

Pin 1

2 Tip

Pin 2

2 Tip

Pin 2

3 Ring

Pin 1, Pin 3
(shorted with sleeve)

3 Ring

Pin 3

7. Technical Specifications

Power Supply

1 x 9V battery (not incl.)

Dimensions

160 x 66 x 120mm

Total Weight

575g

The information in this manual is subject to change without prior notice.