Ohaus TP Series Electronic Balance - Manual (Page 93)

40
If SAFE is displayed, the Print menu has
been locked out. Settings may be viewed
but not changed. See the Menu Lock-Out
Protection section to enable it for making
changes.
To access a submenu:
1. Repeatedly press until the de-
sired submenu is displayed.
2. Press to select the displayed
submenu.
NOTE: NOTE: NOTE: NOTE: NOTE: You must use END to store any
changes you make to the Print menu.
The following sections describe each item
on the Print menu in detail.
ON ON ON ON ON
TARE TARE TARE TARE TARE
2. Press to change the setting.
(Select YES to reset settings or,
no to leave current settings.)
Press to accept the displayed
setting.
Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults Reset to Factory Defaults
This submenu enables you to reset all
RS232 menu selections to the original
factory default settings outlined in the
adjacent table.
To reset to factory defaults:
1. Access the Reset submenu to view
the current setting.
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE
PRINT MENU PRINT MENU PRINT MENU PRINT MENU PRINT MENU
FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS FACTORY DEFAULTS
Baud rate br 2400
Data Bits 7 data
Parity None
Stop Bits 2 stop
Auto Print OFF
Auto Print Interval 1 second
Non Print Low Limit 0
Non Print High Limit 0
Stable Data Only OFF
Numeric Data Only OFF
MODE MODE MODE MODE MODE