Ohaus TP Series Electronic Balance - Manual (Page 103)

50
RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE RS232 COMMAND TABLE
Command Command Command Command Command
Character Character Character Character Character Description Description Description Description Description
? ? ? ? ? Print current mode
nnnA nnnA nnnA nnnA nnnA Set Auto Print feature to “nnn”
(see table).
C C C C C Begin span calibration
xD xD xD xD xD Set 1 second print delay (set x = 0 for OFF, or x = 1 for ON)
E E E E E Exit parts counting or percent weighing
x x x x x IIIII Set Averaging Level to “x”,
where x = 0 to 3 (see table).
L L L L L Begin linearity calibration
M M M M M Same effect as pressing mode button
xM xM xM xM xM Places balance in mode “x”,
where x = 1 to 13 (see table).
If unit or mode is not already
enabled, command will be ignored.
Field: Mode Stab CR LF
Length: 5 1 1 1
blank if stable
“ ? ” if unstable
1 = grams
2 = pennyweight
3 = carats
4 = avoidupois ounces
5 = troy ounces
6 = grains
7 = taels
8 = momme
9 = pounds
10 = pounds:ounces
11 = custom unit
12 = parts counting
13 = percent weighing
nnn = 0 Turns feature OFF
nnn = S Output on stability
nnn = C Output is continuous
nnn = 1-256 Sets Auto Print
Interval
0 = minimum level
1 =
2 =
3 = maximum level
Grams
Pennyweight
Carats
Avoidupois ounces
Troy ounces
Grains
Taels Momme
Pounds
Pounds:ounces
Custom unit
Parts counting
Percent weighing
Error