Ohaus TP Series Electronic Balance - Manual (Page 66)

13
Parts Counting Parts Counting Parts Counting Parts Counting Parts Counting
NOTE: NOTE: NOTE: NOTE: NOTE: Parts counting must first be en-
abled in the Setup menu to use it.
In the parts counting mode, the balance
calculates and displays the quantity of
parts you place on the pan. Since the
balance determines the quantity based
on the average weight of a single part, all
parts must be reasonably uniform in
weight. The accuracy of parts counting
results is determined by the error level
entered in PC Err of the Setup menu.
To perform parts counting, use the follow-
ing procedure:
1. Repeatedly press until PC Con
is displayed.
2. Place an empty container on the pan
(if one will be used).
3. Press .
NOTE: NOTE: NOTE: NOTE: NOTE: To exit or restart parts count-
ing at any time: Press and hold
until PC Con is displayed, then re-
lease it. Return to step 2 to restart, or
press to exit.
ON ON ON ON ON
TARE TARE TARE TARE TARE
ON ON ON ON ON
TARE TARE TARE TARE TARE
Parts Counting Default Settings Parts Counting Default Settings Parts Counting Default Settings Parts Counting Default Settings Parts Counting Default Settings
Parts Counting Mode ........... Disabled
PC Err ......................................... OFF
PC Alternate Display ..... TOTAL PCS
4. Add 5 will be displayed. The balance
needs a sample of the parts to use as
a reference for counting. The default
for the sample size is 5 parts, but this
can be changed to 10, 20, 30, 40, 50
or 100 parts. (Larger samples yield
more accurate results.)
MODE MODE MODE MODE MODE