Setup menu, Setup menu protection – Ohaus TP Series Electronic Balance User Manual

Page 81

SETUP MENU

The Setup menu is used to customize the operation of the balance for your specific
requirements. It contains submenus which enable you to turn features on or off, and
program balance parameters. The following table shows the sequence in which
submenus appear on the Setup menu.

SETUP MENU TABLE

Sets all submenus below to original
factory default settings.
Specifies which weighing units and operat-
ing modes will be available during opera-
tion.
Enables entering a custom weighing unit.

Specifies an allowable percentage of error
for parts counting results.
Specifies the weighing unit for parts
counting alternate display.
Specifies the weighing unit for percent
weighing alternate display.
Enables individual or all menus to be
locked out.
Enables printing a listing of current Setup
menu settings.
Used to exit the Setup menu and store
your selections.

RESET does not appear in menu if menu has been locked out.

* *

CUNIT only appears in menu if custom unit is enabled in SEL submenu.
PC ERR and PC Alt only appear in menu if parts counting is enabled in SEL submenu.
PCTALT only appears in menu if percent weighing is enabled in SEL submenu.

Setup Menu Protection

The Setup menu may be locked out to
prevent unauthorized personnel from
changing settings. To lock out the Setup
menu, refer to the section titled Menu
Lock-Out Protection.

NOTE

NOTE: If -SAFE- is displayed, the Setup
menu has been locked out. Settings may
be viewed but not changed. See the Menu
Lock-Out Protection section to enable it
for making changes.