Ohaus TP Series Electronic Balance - Manual (Page 67)

14
5. To change the sample size, repeat-
edly press until the desired
quantity is displayed.
6. Add the sample number of pieces to
the container.
7. Press .
If Add X is displayed, the sample is too
small to provide results within the se-
lected error level (PC Err of the Setup
menu). X represents the number of addi-
tional parts needed to provide a sufficient
sample.
Add the required number of parts, then
press again.
8. The balance will calculate the aver-
age piece weight based on the net
weight of the sample, and then dis-
play the current number of parts.
9. Add parts to the container as desired
and read the quantity on the display.
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE
ON ON ON ON ON
TARE TARE TARE TARE TARE