Ohaus TP Series Electronic Balance - Manual (Page 63)

10
OPERATION OPERATION OPERATION OPERATION OPERATION
Turning the Balance ON Turning the Balance ON Turning the Balance ON Turning the Balance ON Turning the Balance ON
With no load on the pan, switch the bal-
ance ON by pressing the ON TARE but-
ton. When first switched ON, all segments
of the display should be on as shown in
the illustration.
This display check will be displayed briefly,
then the model number of the balance
followed by a software revision number.
Stabilization Stabilization Stabilization Stabilization Stabilization
Before initally using the balance, allow
time for it to adjust to changes in environ-
ment. The balance need only be plugged
in to warm up. Recommended warm up
period is thirty minutes.
The display will momentarily blank and
then indicate zero. The following table
describes each of the display indicators.
DISPLAY INDICATORS DISPLAY INDICATORS DISPLAY INDICATORS DISPLAY INDICATORS DISPLAY INDICATORS