Ohaus TP Series Electronic Balance - Manual (Page 60)

7
INSTALLATION INSTALLATION INSTALLATION INSTALLATION INSTALLATION
Environment Environment Environment Environment Environment
The balance should always be used in an environment which is free from excessive
air currents, corrosives, vibration, and temperature or humidity extremes. These
factors will affect displayed weight readings.
DO NOT install the balance:
•
Next to open windows or doors causing drafts or rapid temperature changes.
•
Near air conditioning or heat vents.
•
Near vibrating, rotating or reciprocating equipment.
•
Near magnetic fields or equipment that generates magnetic fields.
•
On an unlevel work surface.
LEVELING
FEET (2)
LEVEL
INDICATOR
In-Service Cover In-Service Cover In-Service Cover In-Service Cover In-Service Cover
The cover is placed on the balance
before shipment. If desired, the
adhesive pads provided may
be used to secure the cover to
the balance to avoid possible
movement.
Peel the backing off of one side
of each adhesive pad and press
the pads onto the top of the
balance as shown in the dia-
gram.
Remove the backing from the
top of the pads, place the cover
on the balance and press down
on the pads.
Leveling the Balance Leveling the Balance Leveling the Balance Leveling the Balance Leveling the Balance
The balance is
equipped with a level
indicator on the rear and
two adjustable leveling
feet (see diagram). Ad-
just the leveling feet until
the bubble appears in the
center circle of the indicator.
ADHESIVE
PADS
COVER