Ohaus TP Series Electronic Balance - Manual (Page 89)

36
Percent Weighing Alternate Display Percent Weighing Alternate Display Percent Weighing Alternate Display Percent Weighing Alternate Display Percent Weighing Alternate Display
In addition to displaying the percentage of
material on the pan in relation to a refer-
ence, the percent weighing feature offers
an alternate display mode. Using the Pct
Alt submenu, you can specify the follow-
ing for the alternate display:
•
An alternate unit/mode for displaying
weight or percentage of the load (can
be any unit/mode the balance offers
regardless of which units are enabled
in the Unit Selection submenu).
•
NET or TOTAL
NET permits repetitive taring and
causes the alternate display to show
only the weight of material added
since the last tare.
TOTAL causes the display to show
the total weight or percentage of all
material on the pan. Taring only af-
fects the primary percentage display.
•
Turn alternate display OFF.
To select NET, TOTAL or OFF for the
alternate display, use the following proce-
dure:
1. Access the Pct Alt submenu to dis-
play the current setting.
2. Press to change the setting.
Press to accept the displayed
setting.
When is released, PCT ALT will be
displayed again and the Setup menu will
be returned.
NOTE: TOTAL % = default setting. NOTE: TOTAL % = default setting. NOTE: TOTAL % = default setting. NOTE: TOTAL % = default setting. NOTE: TOTAL % = default setting.
MODE MODE MODE MODE MODE
ON ON ON ON ON
TARE TARE TARE TARE TARE
ON ON ON ON ON
TARE TARE TARE TARE TARE
Example shows alternate display set for
TOTAL grams and NET grams.