Ohaus TP Series Electronic Balance User Manual

Page 85

Set the value of all digits in the same
manner. If an error is made, you can

press

to backup to the desired

digit and change it.

After the last digit is entered, the
display will show the current expo-
nent. The exponent is shown on the
display preceded by the letter E.

There are 7 exponent values which you
can choose from (see table).

Press

to change the exponent.

Press

to accept the displayed

exponent.

When

is released, the display

will show the current least significant

digit.

The least significant digit is the digit in the
last decimal place on the display. The
selection you make causes the balance to
count by 1’s, 2’s or 5’s in this position.
There are 6 LSD settings you can choose
from (see table).

10. Press

to change the LSD.

11. Press

to accept the displayed

LSD.

When

is released, C Unit will be

displayed again and the Setup menu will
be returned.

EXPONENTS

E-3

Moves decimal point 3
places to the left.

E-2

Moves decimal point 2
places to the left.

E-1

Moves decimal point 1
place to the left.

Leaves decimal point

Leaves decimal point
in normal position.

in normal position.

Moves decimal point 1
place to the right.

Moves decimal point 2
places to the right.

Moves decimal point 3
places to the right.

LSD’s

LSD .5*

Adds one decimal place
display counts by 5’s.

LSD 1

Display counts by 1’s.

LSD 2

Display counts by 2’s.

LSD 5

Display counts by 5’s.

LSD 10

Display counts by 10’s.

LSD 100

Display counts by 100’s.

* Sensitivity to vibration is increased

with this LSD setting.

PRINT

MODE

TARE

MODE