Ohaus RANGER ADVANCED COMPACT COUNTING SCALES Manual en - Manual (Page 43)

Settings in the menu Ranger RP
43
4.6.2 COM1/COM2 -> PRINTER – settings for protocol printout
This menu item only appears if the mode "Print" or "A.Print" is selected.
4.6.3 COM1/COM2 -> PARAMET – communication parameter
4.6.4 COM1/COM2 -> RESET COM1/RESET COM2 – resetting serial interface to factory
settings
4.6.5 OPTION – configuring options
If no option is installed or is not yet configured, N.A. appears in the display.
tEmPLat Selecting protocol printout
StdArd • Standard printout
tEmPLt1 • Printout in accordance with Template 1
tEmPLt2 • Printout in accordance with Template 2
ASCi.FmtT Selecting formats for the protocol printout
LINE.Fmt • Line format: MULtI (multi-line) or SINGLE (single-line)
LENGtH • Line length: 0 ... 100 characters, appears only with line format MULtI
SEPArAt • Separator: , ; . / \ _ and space; appears only with line format SINGLE
Add LF • Line feed: 0 ... 9
bAUd Selecting baud rate: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400 baud
PAritY Selecting parity: 7 none, 8 none, 7 odd, 8 odd, 7 even, 8 even
H.SHAKE Selecting Handshake: NO, XONXOFF, nEt422, nEt485 (network operation
as per RS485 standard via the optional RS422/RS485 interface, only for COM1)
NET.Addr
Assigning network address: 0 ... 31, only for NET 485
ChECSuM Activating checksum byte (appears only in TOLEDO Continuous mode)
Vcc Switching 5V voltage, e.g. for a bar code reader, on / off
SUrE? Confirmation inquiry
• Reset interface settings to factory settings with Yes
• Do not reset the interface settings with No
EtH.NEt Configuration of the Ethernet interface
IP.AddrS • Enter IP address
SUBNEt • Enter Subnet address
GAtEWAY • Enter Gateway address
USb
Configuration of the USB interface
USb TEST • Test of the USB interface. After the test has been passed, rEAdY appears in the
display.